ODME MARPOIL

The Marpoil ODME provides the detection of oil particles and elimination of the effects of non-oil contaminants in a continuous flow of sample water. The Sample Water is preconditioned with a de-aerator followed by a high shear emulsification process, and then enters a measuring cell with two cylindrical glass cells through which light within the red spectrum is passed. The signals are transmitted to and tested in a microprocessor for identification of the content and measuring of the oil contaminants. The results are sent to the Control PC where the ship staff monitors the discharging operation.

Special Features

- No Consumables

- Automatic self-calibration

- Automatic flushing before and after use

- One-Piece Sampling Pump with Bulkhead penetration ready for installation

- Two Diameter 26mm bulkhead penetrations for sample water

- System Design provides for low installation cost

Advantages of Marpoil ODME

- Simple and compact design, easy installation & Maintenance

- User friendly control PC in the control room for system operation

- Most components are installed in the engine room for easy maintenance

- Flow Sensor is of Pitot Tube Design, which gives better accuracy and measure wider range of flow

- The measuring unit is cleaned by fresh water flushing automatically; chemical washing not necessary

- Separate fresh water tank for the system is not required

- Approved and up-gradable to monitor oil like noxious liquid substances

- Worldwide service support and full inventory of spare parts available